From here


The accident occurred on Oct 13th, 2026.
While a Cessna210 has an ample aft CG range, I doubt it was anywhere near limits after engine separation. Nonetheless, it is amazing that the 74YO pilot managed to maintain sufficient control to escape with only minor injuries.
While narrative sais it “landed upside down” it is unlikely since it seems to have lost at least one gear leg in the process. More accurate would probably be that it ended up upside down.
The engine picture shows the aft RH engine mount leg severed with uniform colour, perhaps pointing to a sudden breakage, but no other indication I can see about the separation.
Propeller damage indicates the engine+propeller assembly was likely rotating upon impact.
FR24 data indicates the aircraft flew 80 flights and around 100hrs in the last year.
For once, the radio call “I lost my engine” makes sense.
But yes, it is remarkable. One would think that you immediately lose control of the aircraft when that happens, which apparently did not happen.
I don’t get a clear picture of that. How can an engine alone rotate. Must have been a very short time between detaching and off-field landing.
What’s the secret? Keep the speed up high enough to not have an aft-CG-stall?
Flight time according to the article was less than a minute (from FR24).
So maybe he was still very low, and had time to ALMOST put it down before it detached completely? A very lucky pilot.
That part of the world is some of the most unfriendly to steel due to corrosion as you will find. I would not be surprised to find out that there was corrosion on the engine mount.
(other than early 1960’s, not the case) Cessna 210’s have an all aluminum alloy engine mount, other than mounting hardware. Not that aluminum is immune to corrosion…
This picture shows the structure
And then the engine sits on four aluminum legs bolted to the crankcase

UdoR wrote:
How can an engine alone rotate
If it is turning 2700RPM on a metal propeller, rotating momentum is quite high and as the engine separates and stops, most of that momentum is transferred to the engine until both engine and prop turn at the same speed (maybe 300 rpm ?) in the air during their fall
@Antonio wrote:
… Cessna 210’s have an all aluminum alloy engine mount…
Very interesting! I didn’t know this – thanks for sharing it.
Antonio wrote:
I doubt it was anywhere near limits after engine separation
I stand corrected: I run the numbers for our P210 with one pilot and half fuel, removing 470lbs for engine and prop from 18" fwd of the datum, as listed on the POH, and CG is only 1" or 2 " aft of limits. Probably right on the edge with a full tank of fuel. Mine includes turbocharger and associated systems: surely the NA engine in the OP was lighter.
It must have been a controllable airplane unless he had some aft load.